I Stood at My Bench for Forty Minutes This Morning and Could Feel Every Finger
I quit trying to heat the whole garage and started heating the five feet around my bench. The breaker hasn't tripped once since.


This morning I stood at my bench for forty minutes. It was 24 degrees outside.
I could feel every finger the whole time.
If you work in a cold garage, you know why I'm writing this down.
For six winters my shop was closed from Thanksgiving to March. Not because I wanted it closed. Because of my hands.
Thanksgiving to March, the shop was closed
I've run machines at the paper mill for twenty-nine years. The garage is mine on nights and Saturdays. I spent ten years filling it with tools.
Then the first cold snap came.
Ten minutes at the bench and I couldn't feel the chisel. Twenty minutes and I didn't trust my hands near the saw.
The glue wouldn't set either. I'd clamp a joint at night and find it chalky in the morning. Wood glue doesn't cure right in a cold shop.
My wife Diane said it every December. "You're going to lose a finger out there, Ray."
So the projects sat. The rocking chair I promised my daughter sat for two winters with one arm on it.
Every time I started the saw, the lights went out
I tried everything the hardware store sells.
A propane torpedo heater. Loud, and the fumes meant cracking the big door, so the heat went right out with them.
Then a box heater on the floor by the bench. That one was worse.
Every time I started the table saw, click. Dark garage. Saw winding down in the middle of a cut. Walk to the panel in the cold, flip it back, start over.

And it sat right there on the floor in the sawdust, with its coils glowing orange. I spent more time watching that heater than watching my work.
"Ray, you're not heating your bench. You're heating the ceiling."
My brother-in-law the electrician told me what I was doing wrong
Mike has wired houses in Eau Claire for 35 years. He came out for a beer on a Saturday, watched the breaker go, and laughed at me.
Then he explained it.
A floor heater pulls 1,500 watts. That's about 12 and a half amps. My table saw pulls 13 to start. Put them on the same garage circuit and the breaker does exactly what it's built to do.
And all that heat? Warm air rises. It goes straight up to the rafters and out the garage door seals, while the floor and the bench stay cold. In a garage you can run a heater all day and still be cold where you stand.
"Quit trying to heat the garage," he said. "Heat the five feet you work in."
He called it spot heating. Small heat, aimed at you, up off the floor, using so little power the saw never notices.
The next weekend he brought one over.
Half off today · Free shipping · 90-day money back
It was on the wall over my bench in about a minute
It weighs 2.7 pounds. Less than my block plane.
Two hooks come in the box. Mike hung it over the end of the bench, plugged it into the outlet that was already there, and pressed the button.
Warm air in about 30 seconds. Right down on my hands.

I didn't believe it would matter in a two-car garage. So I put a thermometer on the bench.
It read 41 when I came out. Ten minutes later, at the bench, it read 67.

The far corner by the lawn mower is still cold. I don't work over there.
Plugs into any outlet · No tools, no electrician
It runs on less power than my shop vac
Most space heaters pull 1,500 watts, all the time.
This one runs on as little as 400. Its top setting is 800.
That's why it doesn't fight the saw for the circuit. The saw and the heater run together now. I haven't opened that breaker panel since October.
Inside is a PTC ceramic core, the same kind electric cars use to keep their batteries warm. It regulates itself: the hotter it gets, the less power it pulls. A fan pushes the warm air out and down, so it reaches your hands in seconds instead of floating up to the rafters.

On low it costs me about a nickel an hour. A morning in the shop is cheaper than the coffee I bring out with me.
Nothing on the floor for sawdust to pile on
This was the part Diane cared about.
It hangs up on the wall, above the bench. No glowing coils. No cord across the floor to catch my boot while I'm carrying a board to the saw. No hot box sitting in the shavings.
It shuts itself off if it ever tips or overheats. That's the PTC core again.

Diane comes out with coffee now and stays to talk. She never did that when the old heater was on the floor.
90 days to try it. Not warmer? Send it back.
I work bare-handed now. All winter.
All last winter I was in the shop maybe six days. Since October I've been out there every morning.

The glue sets overnight again. The rocking chair has both arms and a finish on it. It goes under the tree in six weeks.
Mike said a 240-volt line for a hanging garage heater would have run me $1,200 to $1,500. This plugged into the outlet I already had.
It's not in the hardware stores. The company sells it on its own website, and it keeps selling out. My neighbor Tom missed the last batch by two days.
Why I didn't just buy another floor heater
| Cozy Cove Pro | Floor heater | Propane torpedo | |
|---|---|---|---|
| Where it goes | On the wall, over the bench | On the floor, in the sawdust | On the floor |
| Trips the breaker | Never has, 400W | Every time the saw starts | No, but needs a tank |
| Heat on your hands | About 30 seconds | Goes to the ceiling | Goes out the door you cracked |
| Fumes | None | None | Door has to stay open |
| Tips over | Can't, it's on the wall | Yes, with hot coils | Yes |
| Money back | 90 days | 30 days, if any | Rarely |
I posted the thermometer in my woodworking group
Diane told me to. Now I get a message about it every other day.

What 17,673 buyers say
Hung it over my workbench in the garage. I can work bare-handed in January now. The rest of the garage is cold and I don't care.
My old heater and my saw could not run together. This one and the saw run all morning on the same outlet.
I went through two floor heaters in two winters. They hum, they get hot to touch, and they warm about one chair. This one is quiet and up out of the way.
One for his shop, one for my sewing room off the garage. We both stay out there all afternoon now.
Cozy Cove Pro: today's price
An electrician quoted $1,200 to $1,500 to wire a hanging garage heater. This one plugs into the outlet you already have.
Black Friday code BF26 is applied for you at checkout. Nothing to type.
- Free shipping, 2-3 days from a US warehouse
- 90-day money-back guarantee
- Wall hooks and remote included
- 17,673+ five-star reviews
Advertorial / sponsored content. This page is a paid advertisement, not independent news or a product review. Home Informer is not the seller or manufacturer of the products featured here. We earn a commission when you buy through links on this page, at no extra cost to you. Prices, offers and availability are set by the seller and can change.
Home · Privacy · Terms · Contact
© 2026 Home Informer